30
FEATURES AND CONTROLS
Instrument Cluster
Rider Information Center
The rider information center is located
in the instrument cluster. All segments
will light up for one second at start-
up. If the instrument cluster fails to
illuminate, a battery over-voltage may
have occurred and the instrument
cluster may have shut off to protect
the electronic speedometer. If this
occurs, your POLARIS dealer can
provide proper diagnosis.
The information center is set to
display standard units of measurement
and a 12-hour clock at the factory. To
change to metric and/or a 24-hour
clock, see page 31.
1. Gear Indicator - This indicator displays gear shifter position.
H = High Gear
L = Low Gear
N = Neutral
R = Reverse Gear
P = Park
-- = Gear Signal Error (or shifter between gears)
2. Fuel Gauge - The segments of the fuel gauge show the level of fuel in the fuel tank.
When the last segment clears, a low fuel warning is activated. All segments including
the fuel icon will flash. Refuel immediately.
Tip: If the fuel icon fails to display, an open or short circuit has occurred in the fuel sensor circuit. Your
POLARIS dealer can assist.
3. Information Display Area - This area displays odometer, trip meter, engine hour meter
and programmable service hour interval.
4. Under / Over Voltage - This warning usually indicates that the vehicle is operating at an
RPM too low to keep the battery charged. It may also occur when the engine is at idle
and high electrical load (lights, cooling fan, accessories) is applied. Drive at a higher
RPM or recharge the battery to clear the warning.
5. Clock - The clock displays time in a 12-hour or 24-hour format. See page 31 for reset-
ting instructions.
6. Service Indicator - A flashing wrench symbol alerts the operator that the preset service
interval has been reached. Your POLARIS dealer can provide scheduled maintenance.
See page 32 for resetting instructions.
7. 4X4 Indicator - This indicator illuminates when the 4X4 system is engaged (switch is
on 4X4).
To Next Page
Loading...
Need help?
General
