Polaris SmartGo PVCR 0930

33
the
charging
base
before
expiration
of the
cleaning
program.
Power
consumption rate
differs depending
on the type of
vacuumed
surfaces.
The time of
autonomous
operation of the
vacuum cleaner
depends
complexity of a
vacuumed room,
on the amount of
debris, and on the
vacuuming mode.
4
The
vacuum
cleaner
does not
perform a
scheduled
work.
The vacuum
cleaner is de-
energized.
The vacuum
cleaner is
discharged.
The dust bag is
completely full.
- Turn on the
vacuum cleaner.
- While the vacuum
cleaner is under
the standby mode,
make sure that it is
fully charged and
has got enough
energy to operate.
- Clean the dust
bag
5.
The
vacuum
cleaner
cannot be
run from
the
control
unit (its
reach
counts 5
meters).
Electric battery of
the remote control
unit is completely
discharged
The vacuum
cleaner is de-
energized / its
electric battery is
completely
discharged.
The remote
control unit
emitter is
contaminated
The presence of
noises from other
IR-radiation
sources.
- Replace electric
batteries
- Turn on / charge
the vacuum
cleaner.
- Wipe the remote
control unit
emitter with a
piece of soft cloth.
Keep the control
unit away from
other IR-radiation
sources.
Attention! If it is impossible to resolve the problem on your own using the steps described
above, please contact your POLARIS Authorized Service Center.
STORAGE
Electric devices shall be stored in a dry and clean room at an ambient temperature of up to 40ºC
under relative humidity of 70% provided the absence of any ambient dust, acidic or other fumes
which can adversely influence on electric device materials.
Keep the device out of the reach of children.
TRANSPORTATION