26
CLEANUP PROGRAMS.
To improve the cleanup quality, the vacuum cleaner has got different programs which can be
launched on the control panel, or the control unit.
At switching over from the basic program to another mode with subsequent relaunch the basic
program, then the vacuum cleaner reschedule the cleanup path and can vacuum an area having
been already cleaned.
The start of a cleanup program shall be preceded by making sure that the vacuum cleaner is
activated and is under the Pause mode. If the vacuum cleaner is under the Sleep mode, you
should push the button on the device or the remote control unit to activate the device.
1. Classic or basic cleanup program.
Under this program, the vacuum cleaner starts from cleaning along walls, then across the floor of
an area under vacuuming. This program is recommended during cleaning any carpeted surfaces.
To launch it, push the button on the device or on the control unit. (Fig. 13)
2. Navigation mode
To vacuum under the navigation mode, push the button on the device or on the remote
control unit; this causes the vacuum cleaner to move along parallel lines during vacuuming. At
that, it automatically calculates the space left to be cleaned. (Fig. 14)
3. Suction power increase mode "Maximum".
The "Maximum" cleanup mode enables the vacuum cleaner to operate with an increased suction
power. To activate the mode, push the respective button on the control unit . (Fig. 15)
4. Spiral motion (Local cleanup).
Spiral motion mode ("Local cleanup") is intended fro cleaning intensively contaminated areas. To
start cleaning, you should push the button on the vacuum cleaner or the control unit (Fig.
16)
5. Cleanup along walls.
To start cleaning along walls, push the respective button on the control unit (Fig. 17)
6. Return-to-Base.
If the electric battery get discharged during cleaning, the vacuum cleaner automatically returns
to the base. It can also be directed to the base by pushing on the control unit or on the
vacuum cleaner.
SETTING THE CURRENT TIME AND THE CLEANUP START TIME.
By using buttons on the control panel you can set a desirable time of starting the cleanup. At that,
the current time shall also be set.
Having the timer pre-adjusted, the vacuum cleaner automatically turns on and starts cleaning
daily at preset time. I/O switch on the device body shall be in ON position, the accumulator shall
be charged and connected.
Setting the current time.
Turn on the vacuum cleaner under the Pause mode. Hold down button for 2 seconds.
This causes the vacuum cleaner to utter a beep, the current time setting menu illuminates on the
display. "Hour" indicator light is flashing on the display.
To set the time, push and buttons on the device body, push the button to switch over from
hours to minutes, then to the time indication mode selection (AM/PM), and to week days. Once
To Next Page
Loading...
