Polaris SmartGo PVCR 0930

32
Troubleshooting during vacuuming.
#
Problem
Possible reason
Recommended
actions
1
The
vacuum
cleaner
cannot be
run or
charged
No contact with
the base.
The base is not
connected to the
adapter.
Engagement of a
non-standard
adapter for
charging.
- Check correction
of connection
between the
vacuum cleaner
and the base.
- Connect the base
to the adapter.
- Use a standard
adapter for
charging.
2
The
vacuum
cleaner
jerks
while
standing.
A foreign item has
got ingested into
or wound around
the wheels drive of
the brushes drive
The vacuum
cleaner tries to get
free automatically.
If this is impossible
then help the
device.
3
The
vacuum
cleaner
directs to
The vacuum
cleaner directs to
the base at a low
level of charge.
Charge the vacuum
cleaner.
adapter and electric
battery.
13
Bumper
sensors
failure
Beeps
4
times
Wipe the sensor
display. Restart the
vacuum cleaner. If a
problem cannot be
eliminated, contact
SC.
14
Navigati
on
failure
Beeps
4
times
Restart the vacuum
cleaner. If a problem
cannot be eliminated,
contact SC.
15
Low-
charged
electric
battery
Recharge the
accumulator by any of
methods described in
Operation Manual.
While the vacuum
cleaner is under the
standby mode, make
sure that it is fully
charged and has got
enough energy to
operate anytime.
16
Filters
are
choked
with
debris
Clean the filters.
Remember to do it
each time after
vacuuming.