ENGINE
3.28
ENGINE HEAD REASSEMBLY CONT’D
8. Install breather reed (G) into rocker cover (H).
Lightly apply black RTV sealant to the outer
edges of the breather reed. The reed has a tab
and will assemble one way only. Apply Loctitet
271 (PN 2871954) to the bolts. Torque the
breather bolts to 27--33 in. lbs. (3--4 Nm).
NOTE: When applying RTV, do not get any RTV
inside the reed assembly.
9. Place a new seal (I) into the bottom of the cover.
Be sure the seal is seated into the cover properly.
G
I
H
27--33 in.lbs.
(3--4 Nm)
8.5-9.5 ft. lbs.
(12-13 Nm)
REMINDER: Before assembly, clean the bolts and
bolt holes with Primer N (PN 2870585) to remove any
debris. This will ensure proper sealing when installing
bolts and new Loctitet.
10. Install rocker cover. Apply Loctitet 271 (PN
2871954) to the bolts. Torque bolts to 8.5-9.5 ft.
lbs.12-13 Nm).
Rocker Cover Bolt Torque:
8.5-9.5 ft. lbs. (12-13 Nm)
11. Install thermostat (J). Apply Loctitet 271 (PN
2871954) to the bolts of the cover. Torque bolts to
8.5-9.5 ft. lbs. (12-13 Nm).
J
Thermostat Housing Bolt Torque:
8.5-9.5 ft. lbs. (12-13 Nm)
12. Apply pipe dope or Teflon tape to pipe threads of
temperature sender (K). Install and torque to
16-20 ft. lbs. (22-27 Nm).
Apply pipe dope or Teflon tape to threads.
K
Temperature Sender Torque:
16-20 ft. lbs. (22-27 Nm)
Enfocus Software - Customer Support
To Next Page
Loading...
