35
CONTROL AND PARTS FUNCTIONS
Engine Electrical Switches
1. Override Switch (Reverse Speed Limiter) - This vehicle is equipped with a re-
verse speed limiter system. To obtain additional power while backing up, depress
the override button. WARNING: Never activate the override button while throttle
is open as loss of control may result, causing severe personal injury or
death.NOTE: The override switch also allows activation of Demand 4 Drive (All
Wheel Drive) in reverse, if Demand 4 Drive switch is on.
2. Main Switch - This switch must be turned clockwise to the “on” position to start
the engine.
3. Emergency Engine Stop Switch - The engine will not start or run when the
switch is in its “off” position. Its purpose is to provide the operator with a quick
means of engine shutdown in case of stuck throttle or other emergency. NOTE:
Both the main switch and the emergency engine stop switch shut off all electrical
powertothe entire vehicle includinglights. To stopthe engine,slidethestopswitch
right or left to the “off” position.
4. Engine Start Button - Slide the stop switchto the center “run”position and push
up to start.
WARNING
Backing your ATV can be dangerous!
You could hit an obstacle or person behind you; or the vehicle could tip
over rearward on a steep incline causing severe injury or death.
Alwaysback slowly avoiding excessive speed anddo notuse thereverse
speed override switch system unless additional power is required for ve-
hicle movement.
Avoid backing on steep inclines.
Avoid turning at sharp angles in reverse.
1
2
3
4
RUN
OFFOFF
Push Up to Start
To Next Page
Loading...
Need help?
General
