120
MAINTENANCE
Cleaning Your ATV
Keeping your ATV clean will not only improve its appearancebut itcan alsoextend
the life of various components. With a few precautions, your ATV can be cleaned
much like an automobile.
Washing
If a high pressure type car wash system is used, extreme care must be taken to
avoid water damage to the wheel bearings, transmission seals, body panels,
brakes and warning labels. Many expensive repair bills c an resultfrom using high
pressure detergent systems.
NOTE: If a high pressure car wash is used, grease all zerk fittings immediately af-
ter washing. Also run the vehicle to evaporate any water that might have entered
the engine or exhaust system.
The best and safest way to clean your ATV is with a garden hose and a pail of mild
soap and water. Use a professional type washing mitten, cleaning the upper body
first and the lower parts last. Rinse with water frequently and dry with a chamois
to prevent water spots. NOTE: If warning labels are damaged, contact your a Po-
laris dealer for free replacement.
Waxing
Your ATV can be waxed with any quality brand automotive paste wax. Avoid the
use of harsh cleaners since they can scratch the body finish.
CAUTION: Certain products, including insect repellants and chemicals, will
damage plastic surfaces. Care must be taken when using these products near
plastic s urfaces.
Storage
IfyourATVistobeplacedinex-
tended or off season storage, the fol-
lowing steps should be taken to pre-
serve its condition.
1.Perform all necessary repairs and
thoroughly clean the ATV.
2.Turn the fuel valve to “off” and
drain the carburetor.
3.On 2-cycle engines, remove the
spark plug and pour approxi-
mately one ounce of injection oil
into the cylinder. Operate the
starter for a few seconds and re-
install the spark plug.
4.On 4-cycle engines, remove the spark plug and pour approximately one ounce
of Premium 4 oil into the cylinder. Operate the starter for a few seconds and
reinstall the spark plug.
5.Remove the battery. Store it in a c ool, dry place out of the sun.
6.Lubricate suspension pivot points, lower steering post, all U-joints (if any) and
rear axle fittings (if any).
Drain tube
attached
here
Drain Screw
To Next Page
Loading...
Need help?
General
