74
BATTERY
Battery Removal
1.Disconnect hold down straps holding the electrical box and battery in position
and remove battery cover.
2.Remove the battery vent tube from the battery.
3.Disconnect the black (negative) battery cable first.
4.Disconnect the red (positive) battery cable next.
5.Lift the battery out of the ATV, being careful not to tip it sideways and spill any
electrolyte.
CAUTION: If electrolyte spills, immediately wash itoff with a s olution of one table-
spoon baking soda and one cup water to prevent damage to the ATV.
Battery Installation
WARNING: To avoid the possibility of explosion, always connect battery cables
in the order specified. Red (positive) cable first; black (negative) cable last.
1.Set the battery in its holder.
2.Install the battery vent tube. It must be free from obstructions and securely
installed. If not,battery gases could accumulate and cause an explosion. The
tube should be routed away from the frame and body to prevent corrosion.
Avoid skin contact with electrolyte, severe burns could result.
3.First connect and tighten the red (positive) cable.
4.Second connect and tighten the black (negative) cable.
5.Reinstall battery cover and attach the hold down strap.
6.Verify that cables are properly routed.
NOTE:
DWhen your ATV is placed in storage for three months or more, the battery
should be removed, charged to proper level, and stored in a cool dry place.
DBefore reusing, take the battery to your dealer for testing and recharging.
DPower plug leads may need to be bent down so that the battery cover may be
installed.
To Next Page
Loading...
Need help?
General
