83
MAINTENANCE
Lubrication Recommendations
13. Front A Arm
Pivot Shaft
Grease**∆ Locate fitting on pivot shaft and
grease with grease gun.
Every 3
months or 50
hours
14. Counter Bal-
ance Housing
(400)
SAE 10/30 Check level on dipstick and add oil as
necessary. Change annually. To
change oil see page 108.
Check month-
ly and change
annually
15. Steering Post
Bushings
Grease** Locate fittings on steering post and
grease with grease gun.
Every 3
months or 50
hours
16. Rear Axle
Bearing
Grease** Locate fittings and grease Every 3
months or 50
hours
17. Swing Arm
Bushings
Grease** Locate fittings on swing arm and
grease with grease gun.
Monthly or at
20 hours
18. Upper Control
Arms
Grease**∆ Locate fittings and grease Semi-annually
19. Lower Control
Arms
Grease**∆ Locate fittings and grease Semi-annually
20. Rear Wheel
Hub Bearing Car-
rier
Grease**∆ Locate fitting and grease Semi-annually
21. Rear Anti-Roll
Bar
Grease Locate fitting and grease Semi-annually
* More often under severe use, such as wet or dusty conditions.
**Polaris Premium all Season Grease or grease conforming to NLGI No. 2, such as
Conoco Superlube M or Mobilegrease Special.
+ Grease every 500 miles, or after submerging in water or before long periods of storage or
after pressure washing. Always use Polaris Premium U-Joint Lube for maximum service of
these driveline components (PN 2871515 3 oz.)(PN 2871551 14 oz.).
∆ When suspension action becomes stiff or after washing.
NOTE: Hours are based on 10 mph average.
To Next Page
Loading...
Need help?
General
