11
2.4 I Starting the cleaning cycle
To prevent all risks of injury or equipment damage, comply with the following direcves:
• Bathing is prohibited when the appliance is in the pool.
• Do not use the appliance during shock chlorinaon.
• Do not leave the appliance unaended for an extended period.
• Do not use the appliance if the roller shuer is closed.
• When the control box is powered up, the following symbols light up to indicate:
- The acon in progress
- The cleaning cycle selected (depending on the model)
- that maintenance is required
• The control box switches to standby aer 10 minutes and the screen is switched o. Press any key to exit standby
mode. Standby mode does not stop the appliance if it is in a cleaning cycle.
2.4.1 Selecting the cleaning cycle (depending on the model)
• A cleaning cycle is already congured by default: the symbols are lit.
• The cleaning cycle can be selected at any me, before the appliance starts or while it is operang. The new cycle will
start immediately.
• The cleaner adapts its movement strategy depending on the choice in order to opmise coverage.
Surface to be cleaned
Floor only
Floor + walls + waterline
2.4.2 Launching the cleaning cycle
• Press
Tip to improve cleaning performance
At the start of the bathing season, launch several cleaning cycles in oor only mode (aer removing the large
debris with a net).
Regular use of the cleaner (without exceeding 3 cycles per week) means that your pool will always be clean
and the lter less clogged.
2.4.3 Adjusting the cleaning time (depending on model)
• You may reduce or increase the cleaning me at any me (+/- 0.5 H).
• Press the buon:
Durée
normale
- 0.5 H
+ 0.5 H
Normal
duraon
To Next Page
Loading...
Need help?
General
