7
1.3 I Operang principle
The cleaner is separate from the ltraon system and can funcon independently. It just simply needs to be connected
to the mains power supply.
It nds the best route to move around and clean the areas of the pool for which it has been designed (depending on the
model: oor, walls, waterline). Debris is sucked in and stored in the cleaner's lter.
The control box enables the cleaning operaons to be started, selected and programmed (depending on the model).
3.5 metres
Minimum
: Control box
: Trolley
: Cleaner
: Floang cable
: Plug
: Power cord
1.4 I Pool preparaon
• This product is intended to be used in pools which are permanently installed. Do not use it in
pools which may be dismantled. A permanent pool is built into the ground or on the ground
and cannot be easily dismantled and stored.
• The appliance must operate in pool water with the following properes:
Water temperature Between 15°C and 35°C
pH Between 6.8 and 7.6
Free chlorine < 3 mg/ l
• When the pool is dirty, especially when commissioning, remove the largest debris using a net in order to opmise the
appliance's performances.
• Remove any thermometers, toys and other objects that might damage the appliance.
To Next Page
Loading...
Need help?
General
