To protect the high-precision technology contained in this device, never leave the Lab in the following
environments for ex-
Lab in the following environments for extended periods of time: high temperature
(+42°C/108°F), high humidity places with extreme changes in temperature (hot and cold), direct sunlight, sandy
or dusty environments such as beaches, damp places, or places with strong vibrations.
Do not drop the device or subject it to severe shocks or vibrations.
Do not push, pull or press on the lens surface
Compliance
Important directions for using
Lithium-Ion Batteries
1. Do not throw into fire.
2. Do not short circuit.
3. Do not disassemble.
4. Do not continue to use when damaged.
5. Dispose correctly after use.
6. Keep away from water.
EU Declaration of Conformity
Hereby, Impossible B.V. declares that the
Polaroid Lab is in compliance with the essential requirements of the Electromagnetic
Compatibility Directive (2014/30/EU), Low
Voltage Directive (2014/35/EU) and RoHs
Directive (2011/65/EU) and other relevant
provisions, when used for its intended
purpose.
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
Caution The user is cautioned that changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This equipment must not be co-located or
operated in conjunction with any other antenna or transmitter.
Note This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC FCC radiation exposure limits set forth for an uncontrolled environment.
End-user must follow the environment. End-user must follow the specific operating instructions for satisfying
RFRF exposure compliance.
exposure compliance.
Industry Canada (IC)
This device complies with part 15 of the FCC Rule and Industry Canada license-exempt RSS standard(s).
Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference
received, including interference that may cause undesired operation. The symbol means that according to
To Next Page
Loading...
Need help?
General
