Optical grade polycarbonate lens, AR coated
Shutter system
Fixed aperture, variable speed shutter
Optical System
LensLens
Fixed focus lens
Focal length
150mm
Lens type
1:2.35 3 element lens system
App System Requirements
Supported phones
iPhone 6 and newer (except iPhone SE)
Most current Android devices
Supported phones and operating systems are subject to change. For a full list please visit
polaroid.com/labworkswith
Safety Information
Caution
Risk of electric shock — Do not open/ Disassemble the motorized roller system
Do not disassemble the device. Incorrect reassembly can cause electrical shock if the device is used again.
Do not immerse the device in water or other fluids.
Do not operate the device in a high humidity environment or very dusty environments. r
Do not attempt to tamper with, adjust or remove the battery and/or the electron- located below the rollers behind
the
ics located below the rollers behind the device’s film door.
Do not attempt to remove the door itself as it is connected electronically to the body of the device. Doing so is
unsafe, will likely damage your device, and will void your warranty.
Do not insert metal objects into the device.
Do not insert any objects into the rollers or gears.
Keep small children and infants away from the device to avoid them being injured by the device’s moving parts.
Do not use or store the device near any heat source or any type of equipment that generates heat, including
stereo amplifiers.
Do not use the device near flammable or explosive gases.
Do not charge the device if you notice any unusual odors, noise, or smoke.
Do not attempt to disassemble the film’s battery or modify it in any way (if using 600-type film). If battery fluid
gets in your eyes, immediately rinse your eyes with fresh, cold running water and seek medical attention
immediately.
Battery and Charger
This device uses a custom lithium-ion battery that is non-removable and mounted inside the Lab body. No other
type of battery can be used. Battery replacement can only be done by authorized service centers. The battery
will rized service centers. The battery will
provide many years of service if properly used. Power consumption varies depending on the environment the
device is used ing on the environment the device is used in and how the device has been stored.
Used immediately after full charge, the battery will power the processing of up to 100 film packs.
Once the battery energy level falls below a certain level, the device will no longer process film. The LED will
blink and signal when it needs to be recharged. This is to avoid a photo getting stuck as it is being processed
through the roller system.
The rechargeable battery is not fully charged at the time of purchase. Charge the battery fully with the USB
charging cable (provided). This usually takes 1-2 hours (can vary depending on usage).
The supplied battery charging cable has been tested to work with the Apple iPhone power adaptors. While it
can be used in other USB ports e.g. computers, USB power adaptors, TVs, cars, etc., correct operation cannot
be guaranteed.
When the device is no longer in use, please recycle it properly.
Usage Environment
To Next Page
Loading...
Need help?
General
