Self-test
Printer will print its configuration after gap/black mark sensor calibration. Self-test printout
can be used to check if there is any dot damage on the heater element, printer
configurations and available memory space.
Self-test printout
Printer model name & Main board firmware version
Printer serial number
Printedmileage
Main board firmware checksum
Serial portsetting
Code page
Country code
Print speed
Print darkness
Label size (width, height)
Black mark or gap size (vertical gap, offset)
Sensor sensitivity
Ethernet settings information (option)
File managementinformation
Print head test pattern
Self-test printout (with printer firmware V7.0 and later version)
Model name
F/W version
Firmware checksum
Printer S/N
Configuration file
System date
System time
Printed mileage (meter)
Cutting counter
26
To Next Page
Loading...