Users can also change the “Printer Name” by another model name in this field, then click
“Set Printer Name” to take effect this change.
Note: After clicking the “Set Printer Name” or “Set IP” button, printer will reset for the
settings to take effect.
8. Click “Exit” button to exit the Ethernet interface setup and go back to Diagnostic Tool main
screen.
Factory Defaultbutton
This function will reset the IP, subnet mask, gateway parameters obtained by DHCP and
reset the printer name.
Web setupbutton
Except to use the Diagnostic Utility to setup the printer, you can also explore and configure
the printer settings and status or update the firmware with the IE or Firefox web browser.
This feature provides a user friendly setup interface and the capability to manage the printer
remotely over a network.
37
To Next Page
Loading...