Polaroid VCM632

9
Select the Equaliser
Press the EQ button on the remote control repeatedly to select: [POP] - [CLASSIC] - [JAZZ] - [ROCK] .
The default EQ setting is POP.
Adjust the Brightness
Press the DIMMER button on the remote control to select brightness level.
Set the Clock
- Manual Setting the clock can only be done in STANDBY mode.
1 In STANDBY mode, press and hold the CLOCK button on the remote control until the hour digits are
ashing.
2 Press the

,

buttons on the remote control to adjust the hour digits while ashing, then press
CLOCK button on the remote control to conrm, then the minute digits will ash.
3 Press the

,

buttons on the remote control to adjust the minute digits while ashing, then press
the CLOCK button on the remote control to conrm.
- Each activated state will be cleared if any buttons are not pressed within 15 seconds.
- During Time Setup press the
BF
button to select 12/24 hour format.
• Time Display
- Press the CLOCK button to show the current time on the display for a few seconds.
Set the alarm Timer
- The clock must be correctly set for the timer to operate correctly.
1 In STANDBY mode, press and hold the TIMER/SLEEP button on the remote control until the hour
digits ash on the display.
2 Press the

,

buttons on the remote control to adjust the hour digits, and then press the TIMER/
SLEEP button on the remote control to conrm, the minute digits will ash on the display.
3 Press the

,

buttons on the remote control to adjust the minute digits, and then press the TIMER/
SLEEP button on the remote control to conrm, the tuner timer will ash on the display
4 Press the

,

buttons on the remote control to select BUZZER, FM, IPOD, DISC mode, and then press
the TIMER/SLEEP button on the remote control to conrm, the display will show the volume level.
5 Press the

,

buttons on the remote control to adjust the volume, and then press the TIMER/SLEEP
button on the remote control to conrm, the display will show the selected timer and “ ” will ash
on the display.
Activate and Deactivate the Alarm Timer
• PresstheTIMER/SLEEP button on the remote control to view the alarm settings or activate the alarm.
- The alarms are active when “ ” both are shown in the display on the front of the unit.
- To deactivate the alarms, press the TIMER/SLEEP. The “ ” will disappear from the display on the
front of the unit.