FM Operation
Auto Scan and Save Preset Station
1 Press the button on the main unit or press the DAB/FM button on the remote control to select FM
mode.
2 Press the INTRO button on the to activate automatic programming. All available stations are
programmed in the order of waveband reception strength.
- The rst programed radio station is played automatically.
• Tune to a Preset Radio Station
- Press the
or
buttons to select a preset number that you want.
Tuning in a Station
Tune in radio stations automatically
• Press and hold the
H
/
G
buttons, the frequency changes down or up automatically until a station
is found.
- The search may not stop at a station with a very weak signal.
Tune in radio stations manually
• Press the
H
/
G
buttons repeatedly until you nd the station you want.
- If reception is still poor, try to adjust the position of the aerial or try to move the radio to another
location.
Presetting Stations Manually
You can preset up to 20 FM stations.
1 Tune in the desired station, then press the PROG button.
2 Press the
/
buttons to select the preset number.
3 Press the PROG button to store the station.
4 Repeat above steps 1 to 3 for each station you want to store in memory with a preset number.
Troubleshooting
To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using
this unit, check the following points before requesting service.
No power
- Ensure that the AC cord of the apparatus is properly connected .
- Ensure that there is power at the AC outlet.
- Press standby button to turn the unit on.
Remote control does not work
- Before you press any SOURCE button, rst select the correct source.
- Reduce the distance between the remote control and the unit.
- Insert the battery with its polarities (+/-) aligned as indicated.
- Replace the battery.
- Aim the remote control directly at the sensor on the front of the unit.
To Next Page
Loading...
Need help?
Power
Audio
Speakers
Weight and Dimensions