geneo+U
38
Performing Ultrasound Treatment Procedure
1. Remove Jewelry and piercing in the treatment area.
2. Cleanse and dry the treatment area.
3. Apply any gel based medium, composed of at least 50% water over the treatment area.
4. Make sure you have a thick layer of applied medium over the treatment area.
5. Select ultrasound treatment option as indicated in pages 18-24.
7. Press “PLAY”, a green light will blink on the applicator.
8. Press the applicator ON button, a blue light will illuminate
9. Make sure you have full contact of the entire applicator electrode on the skin and that movement
is constant - do not stop movement of the active applicator or hold an operating applicator in
the air.
10. Glide the Ultrasound applicator on the treatment area using slight pressure and in small circular,
small elliptical motions, depending on the treated area.
Post Treatment Care
Clean the remaining gel or serum from the skin.
ULTRASOUND TREATMENT
Treatment Parameters
Ultrasound treatment parameters based on clinical experience with the Geneo+U platform, include
two treatment levels, Low and High. Recommended to use Low level over bony areas, around the
eyes and over any sensitive skin areas.
• It is highly recommended to use a hydrating mask or cream with high SPF post treatment.
• If side eect occurs, the patient should consult their treating physician (as written in chapter 2).
To Next Page
Loading...
