Enter the e-mail address associated with this Extension. This e-mail address will receive
all system notification messages. Example: john.smith@bicomsystems.com
Auto Provisioning
■
Set to Yes.
MAC Address
■
Enter the Poly Rove B2 device's MAC address. Example: 001565FF1536. The MAC
address can be found at the back of the device.
Click the Save button.
■
Registering a Device
This section describes how to register a Poly Rove B2 device using DHCP, TFTP, HTTP &
HTTPS.
The following topics are covered:
DHCP
■
TFTP or HTTP & HTTPS
■
DHCP
Configure DHCP
Make sure that the DHCP router is configured to use option 66 to automatically instruct
■
devices with the URL for auto-provisioning. For more information, please see the router
documentation or contact a network administrator.
Device's first boot or user-initiated reboot
The auto-provisioning process will start during the device's first boot or after the reboot
■
process has been initiated by the user. The DHCP server will instruct the device from where to
pick up an appropriate configuration file. If everything is done as described above, you should
have successfully registered your device to PBXware.
Dial *123 to verify registration.
TFTP or HTTP & HTTPS
Open a new browser window and enter the device's IP address, e.g. http://192.168.1.22.
■
Enter username and password and press the Confirm button. NOTE: The factory default
■
login details are as follows: username is admin and password is admin.
Click the System Management tab.
■
Click the Auto Provisioning on the left navigation menu.
■
Go to ITSP Provisioning section.
■
To Next Page
Loading...
