EasyManuals Logo

Poly Savi 7210 User Manual

Poly Savi 7210
7 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
Connect one end of the telephone interface cable to the back of the base
Connect the other end of the telephone interface cable into the dedicated headset port on the desk phone
Adjust the configuration switch on the bottom of the base to default A, which works for most phones. Use configuration D for Cisco phones.
NOTE Use this setup if you are not using the HL10 lifter or EHS cable. In this configuration, press both the headset button on your desk phone and the call
control button on the headset to
answer or end calls. B Desk phone (standard)
Connect one end of the telephone interface cable to the back of the base
Disconnect the handset coil cord from the base of the desk phone and re-connect it to the telephone interface cable junction box
Finally connect the remaining end of the telephone interface cable into the open handset port on the desk phone
Adjust the configuration switch on the bottom of the base to default A, which works for most phones. Use configuration D for Cisco phones.
NOTE Use this setup if you are not using the HL10 lifter or EHS cable and your desk phone does not have a dedicated headset port. In this configuration,
manually remove the handset on your
desk phone and press the call control button on the headset to answer or end calls. C Desk phone + EHS cable (sold separately)
Adjust the configuration switch on the bottom of the base to default A, which works for most phones.
D Desk phone + HL10 lifter (sold separately)
Subscribe headset to base
The headset and base that came in the box are subscribed (connected) to each other. However, if you wish to use a new headset or need to restore subscription
to your current headset, the units
can be subscribed to each other by the following two methods.
Automatic secure subscription
With your system idle, docking a headset will automatically subscribe it to the base, making it the primary headset. The base subscription LED will flash during
subscription process and becomes
solid green when the new subscription is established.
Manual over-the-air subscription
1. With your system idle and your headset undocked, press and hold the Subscription button on the back of the base for 4 seconds. The subscription LED on

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Poly Savi 7210 and is the answer not in the manual?

Poly Savi 7210 Specifications

General IconGeneral
BrandPoly
ModelSavi 7210
CategoryHeadsets
LanguageEnglish

Related product manuals