• To position the microphone on the right or left side, rotate the microphone boom up and
over. Bend the boom so it is approximately 2 finger widths from the corner of your mouth.
NOTE Your headset senses when you change the microphone boom from one side to the other
and syncs the audio specific to each side.
• Gently flex the headband wider if the fit is uncomfortable on your ears.
Charge your headset by placing it in the base's cradle or by using a micro USB cable. The
headset LEDs flash when charging. It takes approximately 2 hours to fully charge your
headset. The LEDs turn off once charging is complete.
NOTE The micro USB cable plugs into a computer or wall charger's USB port.
Headset LEDs What they mean
Off Charging complete
Battery high
Battery medium
Battery low
Battery critical
Check your headset battery status:
• With headset inactive, slide and release the Power switch away from the off position.
Listen to the voice alert or observe the headset LEDs.
Fit and charge
Wear on the right or left
Charge
Check headset battery
status
9