Poly Voyager Focus UC User Manual

To position the microphone on the right or left side, rotate the microphone boom up and
over. Adjust the boom so it points to the corner of your mouth.
TIP Your headset senses when you change the microphone boom from one side to the other and
syncs the audio and controls specific to each side.
IMPORTANT Before using, charge the headset fully to reset the accuracy of the talk time
prompts.
Charge your headset with the charge stand or the micro USB cable. The headset LEDs
flash when charging. It takes up to 2 hours to fully charge your headset. The LEDs turn off
once charging is complete.
NOTE Both the charge stand and micro USB cable can be plugged into either a computer or wall
charger. It is only necessary to plug into a computer to update firmware.
Charge stand Micro USB cable
Headset LEDs Battery status
4–5 blue blinks Battery high
2–3 blue blinks Battery medium
1 red blink Battery low
flashing red Battery critical; Recharge headset
There are several ways to check your headset battery status.
1 Wearing the headset, tap the Call
button and listen to the voice alert (smartphone only).
2 When not wearing the headset, tap any button except the Call button and observe the
headset LEDs.
3 Place the headset in the charge cradle and observe the headset LEDs.
Fit and charge
Wear on the right or left
Charge your headset
Check headset battery
status
9

Poly Voyager Focus UC Specifications

General

Type	Wireless Bluetooth Headset
Connectivity	Bluetooth, USB
Noise Cancellation	Active Noise Cancelling (ANC)
Compatibility	PC, Mac, mobile devices
Wearing Style	Over-the-head
Music Listening Time	Up to 15 hours
Speaker Frequency Response	20 Hz - 20 kHz
Microphone Frequency Response	100 Hz - 8 kHz
Charging	Micro USB
Ear Cushions	Leatherette
Wireless Range	Up to 30 meters (98 feet)
Microphone	Yes, with noise-canceling technology
Smart Sensors	Yes
Warranty	2 years limited warranty
Bluetooth Version	Bluetooth v4.1
Battery Life	Up to 12 hours talk time