Using the diagram, connect your headset system.
OR
NO HEADSET PORT
HEADSET PORT
*Headset design/headset cradle may vary but function is the same.
NOTE Base configuration settings
Desk phone Setting (on bottom of base)
Most phones A
Cisco phones D
Cisco phones with EHS cable A
Your system has a base and compatible Bluetooth headset.
Pair your headset to the accessory base before first use:
1 Slide and hold the headset Power
switch away from the off position until the LEDs flash
red and blue.
2 Put your base into pair mode by pressing and holding the Bluetooth pairing
button on the
back of your base for 2 seconds until the display panel's Bluetooth icon flashes blue and
red.
Pairing is successful when you hear "pairing successful" and "base connected" and the
display panel's Bluetooth
icon turns solid blue.
NOTE Your headset can pair with up to 8 devices but only maintain 2 connections
simultaneously; this includes the base.
Hook up system
Pair headset to base
3
To Next Page
Loading...
Need help?
General