What to do if Polyaire Zonemaster touchpad LCD is not showing anything?
If the Polyaire Temperature Controller touchpad LCD is blank, verify the power supply. Also, check the cable and plug connected to the touchpad.
Why is my Polyaire Zonemaster Temperature Controller touchpad display not normal?
If the Polyaire Temperature Controller touchpad display isn't working correctly, first disconnect the battery. Then, reset the touchpad by turning the power supply off and then on again. If the display returns to normal, plug the battery back in.
What to do if Polyaire Temperature Controller dampers are not responding?
If the dampers of your Polyaire Temperature Controller aren't responding when turned on or off, check the connection between the touchpad and the damper motor. Also, check the 24V AC power supply.
Why is the temperature beyond ±1°C range on my Polyaire Temperature Controller?
If the temperature is beyond the ±1°C range on your Polyaire Temperature Controller, it could be due to the air conditioner not having enough capacity for the area or too much air coming from other areas.
Procedure to enter and exit system setting modes.
Guidance on calibrating the room temperature sensor for accuracy.
How to set the minimum airflow level for the zone.
Instructions for turning the zone on and off using the touchpad.
How to adjust the desired temperature setpoint for the zone.
Procedure to set the damper to its fully open position.
Overview of the system's 5-1-1 programmable scheduling feature.
Steps to configure the system's internal clock and day.
Detailed guide on modifying programmed event times and temperatures.
General| Communication Protocol | Proprietary |
|---|---|
| Control Type | Electronic |
| Input Voltage | 24VAC |
| Differential | Adjustable |
| Enclosure Rating | IP20 |
| Mounting | Wall Mount |
| Type | Zone Controller |
| Sensor Type | Thermistor |
| Temperature Range | 5°C to 35°C |
To Next Page
