Polycom 6000 - Page 30

Note
Transferring an external call to an external number ties up two
lines. If you wish to avoid tying up two lines, please refer to
“Using Network-based Call Transfer”
Note
Using Network-based Call Transfer
The call transfer method is used when you want to transfer a call
without tying up two lines on your phone system. It uses our net
-
work to transfer a call instead of the phone system.
1. Receive a call on your Conference Phone
2. Touch #5 to start the transfer (this will place your caller on
hold)
3. At the dial tone, enter the extension or phone number you
want to transfer the caller to
4. When the transfer party picks up the phone, touch #5
again
5. All three of you will be connected
6. Hang up, and the two parties are connected (without tying
up any of your lines)
If the transfer party does not pick up the phone, touch #6 to return
to the original caller.
(If you want to cancel the transfer before the call is
placed and return to the original call, press the Cancel
soft key.)
The call automatically transfers to the party you specied.
Call Transfer to Voicemail
You may transfer any caller to a specic voicemail box belonging
to any other user on the system.
1. During a call, press the Trans soft key.
2. Press the Blind soft key.
3. When you hear the dial tone, dial *99 plus the desired
extension number.
4. Your line will hang up and the caller will be transferred to
the desired extension or voicemail box.
30