Polycom EagleEye Director - Integrating SoundStructure with HDX and EagleEye Director

2 
EagleEyeDirectorneedsthemixofalltheremoteaudiosothattheEagleEyeDirectorcanproperlydiscernbetwee n
audioplayedintotheroomfromtheremotesites(i.e.,remotetalkers)andthelocaltalkeraudiointhelocalroomwhen
determiningcamerapositioning.
Integrating the SoundStructure with the HDX codec and EagleEye Director
TheHDXcodec/EagleEyeDirectorsolutioncanbeupgradedwithoneormoreSoundStructuredevicesbyreplacingthe
analogoutputs1Land1RfromtheHDXcodecwithtwoanalogoutputs(outputs1and2)totheAmplifierandtwomore
outputs(outputs3and4)totheEagleEyeDirector
asshowninFigure2.

Figure 2 - Integrating SoundStructure with an EagleEye Director uses four balanced audio cables and one conference link interface to
the HDX codec.
Thefourbalancedaudiocablesusedareconnectedstraight‐throughwithpin1connectedtopin1,pin2connectedto
pin2,andpin3connectedtopin3asshowninFigure3.

Figure 3 - A standard balanced audio cable with 3.5mm terminal block connectors.
BeforeconnectingtheSoundStructuresystemtotheHDXcodec,itisrecommendedthatyouenableLiveMusicmodein
theHDXcodec.TodothisnavigatetheHDXUIfromAdminSettings>AudioSettingsandselect LiveMusicmode.This