APPLIANCE EDITION INSTALLATION POLYCOM REALPRESENCE COLLABORATION SERVER V.8.6
I
NSTALLING THE REALPRESENCE COLLABORATION SERVER (RMX) 2000
32 P
OLYCOM REALPRESENCE COLLABORATION SERVER GETTING STARTED GUIDE
– Install an RTM LAN-4 port card and connect the LAN cable to LAN
2.
With Multiple Networks and LAN Redundancy configurations,
connect the LAN cable to LAN 1.
An RTM LAN type card is always required with Multiple Networks
and LAN Redundancy configurations.
• (Optional) RTM ISDN card connections:
If either RTM ISDN card is selected to install with MPMRx card, perform
following steps:
– Connect the E1/T1 cables to PRI ports.
– When the one LAN port RTM ISDN card is installed, connect the
LAN cable to LAN 1; In MPMRx card mode and when the four LAN
ports RTM ISDN card is installed, connect the LAN cable to LAN1
and LAN 2:
Figure 1-10: RealPresence Collaboration Server (RMX) 2000 rear panel view with
cables-MPMRx card(s)
To Next Page
Loading...
