Need help?Do you have a question about the Polycom KIRK Wireless Server 8000 and is the answer not in the manual?
General| Model | KIRK Wireless Server 8000 |
|---|---|
| Protocols Supported | SIP, H.323 |
| Weight | 8 kg |
| Number of Handsets | Up to 1000 |
| DECT Standards Supported | DECT |
| Power Supply | 100-240 VAC, 50-60 Hz |
| Network Interfaces | Gigabit Ethernet |
| Operating System | Linux |
Prerequisites and assumptions for using the configuration guide.
References to other relevant installation and deployment guides.
Definitions of technical abbreviations used in the manual.
Description of the KIRK Wireless Server 8000 and 2500 system components.
Details on backplane, front LEDs, and interface card placement.
Explanation of status LEDs on server modules and interface cards.
Step-by-step instructions for logging into the WEB interface.
Procedure for creating and downloading system configuration and statistics.
Configuration settings for analogue lines, subscriptions, and security levels.
Configuration of date, time, IP address, and network protocols.
Methods for disabling, importing, or retrieving phonebook data.
Instructions for updating base station and server firmware.
Procedures for restarting the system or resetting parameters to default.
Methods for backing up and restoring system registrations and configurations.
Viewing overall system performance and fault-finding information.
Detailed statistics on registered handsets and their activity.
Statistics on base station connectivity, calls, and handover performance.
Information on abnormal call releases, active calls, and media resources.
Setting trace levels and filters to limit detailed communication logs.
Viewing real-time connection information and configuring trace modes.
FCC compliance and safety details for United States operation.
Important safety precautions, warnings, and handling guidelines.
Information on RF compliance, warranty, and software licensing.
Reference table for assigning numbers to base stations and repeaters.
Procedure for updating firmware via a serial connection if default fails.
To Next Page
