Polycom, Inc. 70
MSF Messages (Message Service Function) System Management
Figure 6-10 Call Control tab
2 In the Message pane, type the Local Number (DN) where you want to
send the message.
3 In the Digits to Dial field enter the digits to dial out (‘0’...’9’, ‘*’, ‘#’, ‘P’, ‘p’,
‘S’, ‘s’, ‘,’).
4 In the Display Text field, enter the text you want to send (max 33
characters).
5 Use the Clip Number field to enter text with ciphers.
6 Select one of the Feedback (Call Status = CS) check boxes according to the
desired settings.
7 Select one or more PP Configuration check boxes according to your
handset configuration.
8 In the Call Preferences pane, select the Call type from the corresponding
drop-down list.
9 From the Alerting drop-down list, choose the desired type of ringing.
10 From the PP Volume drop-down list, select the desired volume level.
11 (Only if the selected Call Control is Send Digits Request) Select the Mute
check box to mute tx path towards PP during the period of sending the
digits.
12 Select from the Alerting/Tone drop-down list the desired alerting and
tone type.
13 In the Call Control pane click one of the following buttons:
— Click To Dial Request - in case you want to generate a voice call on
behalf of a PP.
To Next Page
Loading...
Need help?
General
