Polycom KIRK Wireless Server 8000 User Manual

Polycom KIRK Wireless Server 8000 & KIRK Wireless Server 2500 Configuration Guide System Configuration
17 Polycom, Inc.
• ‘Allowing KIRK Wireless Server to Route MSF between Handsets
Internally without Involving 3rd Party Application’
• ‘Allowing or Blocking New Calls’
• ‘Setting the Ringing Mode’
• ‘Setting the Security Level’
• ’Application Interface settings’
• ‘Call Configuration settings’
• ‘SIP Users Feature Codes settings’
Setting the Outgoing Analogue Line Prefix
The Outgoing Analogue Line Prefix specifies which start digit(s) the KIRK
Wireless Server will look for, in an outgoing call. If the KIRK Wireless Server
sees the digit(s), then it will insert a delay between the prefix digit(s) and the
rest of the dialled number.
To set the Outgoing Analogue Line Prefix
1 On the System menu, click Configuration. The System Configuration
page is displayed.
Figure 4-3 Outgoing Analogue Line Prefix settings
2 Type a prefix in the Prefix field, and then click Save to write it to the
system.
Allowing Subscription
To subscribe handsets to the system the system must be set to allow
subscriptions. For detailed information about how to subscribe handsets, see
the user guide for specific handsets. You can find the handset user guides on
www.polycom.com
Note
Click the Refresh button to read the settings from the system.
Note
The system dials the outgoing line prefix cipher, and then waits for the dial
tone before sending the remaining digits of the number.

Polycom KIRK Wireless Server 8000 Specifications

General

Brand	Polycom
Model	KIRK Wireless Server 8000
Category	Server
Language	English