Polycom, Inc. 16
Information page General System Settings
If you have an issue to report about a site, then those files are required with
the report.
To start/stop capture of scenario
1 Repeate steps 1 and 2 from To Get Service Report archive section.
2 Click the Start capture of scenario button. The Grab Events is ended and
the trace level is set to 5.
3 Click the Stop capture button. The Grab Events begins and the trace level
is set back to previous value.
Information page
1 On the System menu, click Information. The System Information page is
displayed.
Figure 4-2 System Information page
2 Click Refresh to load the information.
The System Information page displays hardware and interface information for
each shelf and for each slot in each shelf.
You can view the following information about hardware product change status
(HW PCS) for each slot in each shelf, and information about which Interface
card is used for each slot in each shelf. Furthermore, you can view information
about which software version is currently used. The following figure provides
an example of the information that is displayed on the System information tab.
System Configuration
This section includes the following information:
• ‘Setting the Outgoing Analogue Line Prefix’
• ’Allowing Subscription’
To Next Page
Loading...
Need help?
General
