Polycom realpresence 1800 - Page 37

POLYCOM REALPRESENCE COLLABORATION SERVER V.8.6 APPLIANCE EDITION INSTALLATION
INSTALLING THE REALPRESENCE COLLABORATION SERVER (RMX) 4000
P
OLYCOM REALPRESENCE COLLABORATION SERVER GETTING STARTED GUIDE 35
3. Slide in the RTM ISDN card in the RealPresence Collaboration Server
slot.
ADDITIONAL INFORMATION: An RTM ISDN card must connect directly to an MPMRx
card in the opposite-facing front slot.
Figure 1-11: Install RTM ISDN Card on RealPresence Collaboration Server 2000
4. Push the card into the slot until the ejector levers touch the front edge
of the card cage.
5. Push the ejector levers to their fully closed position.
6. Tighten the captive screws on each side of the rear panel of the card,
securing the RTM ISDN card to the RealPresence Collaboration Server.
Install the RealPresence Collaboration Server (RMX) 4000 as a Stand-
alone System
Instead of installing the RealPresence Collaboration Server (RMX) 4000 in a
rack, you can also put it on a flat surface, or desktop, as a standalone system.
TASK
1. To install the RealPresence Collaboration Server (RMX) 4000 as a stand-
alone system:
2. Place the RealPresence Collaboration Server (RMX) 4000 on a flat
surface or desktop.
ADDITIONAL INFORMATION: The RealPresence Collaboration Server (RMX) 4000
must rest on the four feet at the base of the MCU and must be shifted or
moved into position using the two handles attached to the front.