POLYCOM REALPRESENCE COLLABORATION SERVER V.8.6 APPLIANCE EDITION INSTALLATION
INSTALLING THE REALPRESENCE COLLABORATION SERVER (RMX) 4000
P
OLYCOM REALPRESENCE COLLABORATION SERVER GETTING STARTED GUIDE 45
• Connect the E1/T1 cables to PRI.
• Connect the LAN cable to LAN 1ports.
ADDITIONAL INFORMATION: When LAN redundancy is enabled, LAN 1 is used for
both management, media and signaling network connection. Connect the
media and signaling cable to LAN 2 port. By default this port is used for
signaling, but when LAN redundancy is enabled, LAN 2 is the backup of LAN 1
port.
Connect Cables to the Four-Port RTM ISDN Card of RealPresence Collabo-
ration Server (RMX) 4000
1. To connect cables to the four-port RTM ISDN card of RealPresence
Collaboration Server (RMX) 4000:
2. Connect the E1/T1 cables to PRI.
3. In MPMRx card mode, connect the LAN cable toLAN1 and LAN 2.
Figure 1-18: RealPresence Collaboration Server (RMX) 4000 rear panel with AC
powers and communication cables
To Next Page
Loading...
