Configuring Network Use
3 - 3
Configuring with the Setup Wizard
When you power on your system for the first time, the setup wizard detects
the system’s IP and ISDN connections and leads you through the minimum
configuration steps required to place a call. If you need more information
about these steps, refer to the corresponding sections in this chapter. This
guide covers network types used worldwide. Please note that not all network
types are available in all countries.
The setup wizard allows you to set an administrator password, which allows
you to limit access to the Admin Settings. The default administrator password
is the 14-digit system serial number.
You can run the setup wizard or view the configuration screens in either of
these two ways.
• In the room with the system — Use the remote control to navigate the
screens and enter information. You can use the number pad on the remote
control to enter text just like you can with a cell phone.
• From a remote location — Use a web browser to access VSX Web. To do
this, you need to know the IP address of the system. Polycom recommends
using Microsoft
®
Internet Explorer 6.0 or later.
You can use VSX Web to configure all of the system settings except the remote
management settings. These settings must be configured on the local system
by an administrator. For more information about VSX Web, refer to Accessing
VSX Web on page 5-1.
Make sure you can recall the administrator password if you set one. If you forget the
password, you will have to reset the system, delete the system files, and run the
setup wizard again in order to access the Admin Settings and reset the password.
You cannot set the administrator password from a remote location.
To Next Page
Loading...
Need help?
General
