Polycom VVX201 - Page 7

Enter 5060 into Port field.
■
After this has been completed you should then use the toggling show/hide button to reveal the
■
content of the IP Line Identification
Enter extension into the Address field.
■
Enter extension into the Authentication User ID field.
■
Enter extension secret into the Authentication Password field.
■
Press Save button to preserve changes. Your phone should register after couple of seconds, if
■
not, please reboot your phone.
B) Line configuration on device
Press the Home button on your phone.
■
Go to Settings and press the Select button.
■
Go to Advanced and press the Select button.
■
Enter password and press the Enter button. Please note, factory default password is 456.
■
Press the Select button to enter Administration Settings.....
■
Go to Line Configuration and press the Select button.
■
Go to Line 1 and press the Select button.
■
Go to Address and press the Edit button and enter PBXware extension number. Example:
■
1003 and press the Ok button.
Go to Authentication and press the Select button.
■
Go to User ID: and press the Edit button. Enter PBXware extension number then press the
■
Ok""" button.
Go to Password and press the Edit button, enter PBXware extension secret e.g.
■
%3DfChBz59, then press the Ok button.
Press the Back button three times.
■
Press the Select button for Save Config.
■
Press the Home button on your phone.
■
Go to Settings and press the Select button.
■
Go to Advanced and press the Select button.
■
Enter the password and press the Enter button. Please note, factory default password is 456.
■
Press the Select button to enter Administration Settings.....
■
Go to Call Server Configuration and press the Select button.
■
Press the Select button to enter SIP....
■
Press the Select button to enter Server 1....
■