Name: Polygroup SFX1500
Brand: Polygroup
Rating: 5 (1 reviews)

Questions and Answers:

R
Ricardo SmithJul 26, 2025
Why is my Polygroup SFX1500 Swimming Pool Pump not cleaning the pool properly?
- M
  Manuel LopezJul 26, 2025
  To address a Polygroup Swimming Pool Pump not cleaning the pool properly, ensure the chlorine level is between 1.0 and 1.6 ppm and the pH level is between 7.3 and 7.8. Also, inspect the Filter Cartridge for damage, clean it, or replace if needed. Check for any obstructions at the Strainer Basket, Filter Cartridge, Hose, and Return Fitting. Consider having your pool water tested by a pool supplies store for other required chemicals. Clean the pool and filter more often.
J
Joshua CalhounAug 2, 2025
How to fix no or slow water flow from the Polygroup SFX1500?
- S
  Sharon RobertsonAug 3, 2025
  If you're experiencing no or slow water flow from the Return Fitting of your Polygroup Swimming Pool Pump, first ensure the water level is between the MIN and MAX lines on the Skimmer Seal Ring. Check for any blockages at the Strainer Basket, Filter Cartridge, Hose, and Return Fitting. Clean or replace the Filter Cartridge if it's dirty. Also, clean any dirt that may be blocking the Motor Rotor.
M
Mary JonesAug 9, 2025
What to do if Polygroup SFX1500 motor doesn’t start?
- J
  Jessica LyonsAug 9, 2025
  If your Polygroup Swimming Pool Pump motor doesn’t start or kicks on and off, ensure the GFCI Power Cord is plugged into a grounded outlet and press the RESET button. Check your circuit breaker and reset it if tripped; if the problem continues, have the circuit checked by an electrician. Also, verify the line voltage is between 105VAC and 125VAC.
R
riosvanessaAug 17, 2025
How to stop water leakage at Polygroup SFX1500 Swimming Pool Pump?
- M
  Michael TaylorAug 17, 2025
  If you notice water leakage with your Polygroup Swimming Pool Pump, check the Hose connections with the Skimmer Canister and/or 90° Elbow to ensure they are secured. Make sure the Hose Clamps are properly tightened and inspect the Hose for cracks or holes. For leakage at the bottom of the Canister, ensure the Canister Gasket is correctly placed in the groove and the Pump alignment is correct. If leakage occurs between the Canister and pool wall, verify the Skimmer Gasket Rubber Seal is properly installed and the Skimmer Seal Ring is firmly tightened.