Polygroup SUMMER WAVES RP350 - Setup Instructions

10
1. Set up the pool by following all the instructions that come with the pool. Do not
fill with water until the Filter Pump is properly installed. Locate the Outlet and
Inlet openings on the pool wall.
3. Lubricate the Fitting Gasket with petroleum jelly (not included)
and install the Return Fitting on the Inlet opening of the pool.
2. Lubricate the Fitting Gasket with petroleum jelly (not included) and
install the Suction Fitting on the Outlet opening of the pool.
SETUP INSTRUCTIONS
4. Remove the Filter Pump
w
, Hoses
9
, and Hose Clamps
q
from
the package.
WARNING: CLIMBING HAZARD! PLEASE PREVENT CHILDREN FROM CLIMBING ON THE FILTER CANISTER TO GAIN ACCESS TO THE POOL.
Before assembling your product, please take a few minutes to check the contents and become familiar with all the parts.
11
9
10
4
3
1
2
Inlet
Outlet
Outside Pool Wall
Inside Pool Wall
7
6
1
4
Outside Pool Wall
Inside Pool Wall