7
OWNER’S MANUAL
1. READ ALL INSTRUCTIONS CAREFULLY and get a thorough understanding of what is required to assemble your RP series Filter Pump.
2. It is recommended that you have some petroleum jelly (not included) on hand for lubricating the gaskets.
FILTER PUMP MODEL
RP350
RP400
WATTAGE
20 Watts
25 Watts
AMPERAGE
0.35 Amps
0.2 Amps
FILTER PUMP POWER INFORMATION
PARTS LIST
PRELIMINARY STEPS
FILTER PUMP IMPORTANT NOTES
OWNER’S MANUAL
1. Installer shall follow written instructions provided for operation of the filter pump systems.
2. All electrical components shall be installed in accordance with Article 680 of the National Electrical Code (NEC) “Swimming Pools, Fountains and Similar Installations”
or its latest approved edition.
3. DO NOT use this product to dispense powdered chlorine, shock treatment, or any other type of chemicals as damage to the pump, filter cartridge, and pool will occur.
4. The RP Series Filter Pump systems are manufactured by Polygroup
®
and ETL control number 4000608 and 4006317 - double insulated and grounded - 120 Volts
A.C. - 60 Hz. (All unit must have a minimum of 105 Volts A.C. to start and run properly.)
ITEMSQTY.
2
1
1
2
1
1
1
1
2
4
1
1
1
1
1
PARTS NAME
Fitting Gasket
Suction Fitting
Suction Fitting Washer (SF Washer)
Return/Suction Fitting Lock Nut
Suction Fitting Cap (SF/Service Cap)
Return Fitting
Return Fitting Diverter (RF Diverter)
Return Fitting Plug (RF/Service Plug)
Hose
Hose Camp
Filter Pump Assembly
A) RP350
B) RP400
Vent Screw
Vent Screw O-Ring
Seal Top
Canister Gasket
QTY.
1
1
1
1
1
1
1 set
1
4
1
1 set
PARTS NAME
Filter Pump Canister
Motor Assembly
A) RP350
B) RP400
Type D Filter Cartridge
Pump Motor Body
A) RP350
B) RP400
Rotor Assembly
A) RP350
B) RP400
Volute Housing
Volute Housing Screw Set (2 ea.)
GFCI Power Cord Set`
Filter Pump Port / Fitting O-Ring
Volute Housing Inlet O-Ring
Motor Assembly Screw and Washer Set (4 ea.)
ITEMS
1
2
3
4
5
6
7
8
9
26
To Next Page
Loading...
