Sand Specifications:
Fill the tank with #20 silica sand. You can purchase the sand from your local home improvement or building material store.
12” SAND FILTER (WITH CP2000 PUMP)
SAND PUMP MODEL
10” SAND FILTER (WITH CP2000 PUMP)
200 watts
200 watts
WATTAGE AMPERAGE
1.0 amps
1.0 amps
7
OWNER’S MANUAL
PARTS NAME QTY. PARTS NAME QTY.
Drain Valve Cap
6-Port Valve Drain Outlet Window
Sand Guard
Clamp
CAM-SHAFT Bolt Cap
6-Port Valve O-Ring
1
1
2
1
6
2
1
5
1
1
1
1
1
1
1
1
1
1
6-Port Valve Drain Outlet Cap
Pressure Gauge
Long Hose
Hose Clamp
Locking Pin
Pump
1.5” Fitting O-Ring
6-Port Valve Handle
ITEMS ITEMS
1
2
3
4
5
6
7
8
9
11
12
13
14
15
16
17
18
19
Sand Tank Base
Sand Tank
Center Pipe
A) ST1100
B) ST1600
A) ST1100
B) ST1600
A) ST1100
B) ST1600
ST1100 14” Hose
ST1600 12” Hose
Short Hose
10
6-Port Valve
1
SAND PUMP POWER INFORMATION
Preliminary Steps:
1. READ ALL INSTRUCTIONS CAREFULLY and get a thorough understanding of what is required to assemble your ST series Filter Pump.
2. Before you begin to assemble the pool, identify, count, and check all parts needed for assembly.
3. It is recommended that you have some PETROLEUM JELLY on hand for lubricating the gaskets.
4. Installer shall follow written instructions provided for operation of the filter pump systems.
5. All electrical components shall be installed in accordance with Article 680 of the National Electrical Code (NEC) “Swimming Pools, Fountains and Similar
Installations” or its latest approved edition.
6. The Pump are manufactured by Polygroup
®
and ETL control number 4000608 and 4006317 - double insulated and grounded - 220-240 V.A.C - 50Hz.
SAVE THESE INSTRUCTIONS
PARTS LIST
To Next Page
Loading...
Need help?
General
