Polyprint TexJet echo 2 - Perform Nozzle Test; Prepare for Nozzle Test; Platen Positioning; Initiate Nozzle Check

TexJet® ECHO²
8
Tap on the Settings button
on the top panel. Tap
Maintenance, Print Head
Nozzle Check and Print.
Fig.14: TexJet
®
echo² Nozzle test.
| 03_STEP
| 01_STEP
Perform Nozzle Test
Insert one of the transparent
sheets that come with the
printer on the left corner of
the 34x52cm platen.
| 02_STEP
Press AUTO on the lower panel to set the platen at optimum distance
from the head. When nished, press Start Position Button or Blue
Button to send table inside.
NOTE: If Limit light turns red, lower the table by pressing the DOWN
button, until it turns off and press Start Position Button. When the
platen is inside, a READY TO PRINT indication should be displayed
on the Platen Control panel.
NOTE: If the Blue Led Button is on, tray is not at printing position.
Fig.15: TexJet
®
echo² Nozzle test.