Polytec PSV 300 User Manual


  
                 
   keyskeys
These keys do not have a These keys do not have a function, when the controller is operated via thefunction, when the controller is operated via the
software. When the controller is operated software. When the controller is operated without the software, these keyswithout the software, these keys
are used to change the settings (refer toare used to change the settings (refer tosec
sectiotionn 5.15.12.12.1).).

  
indicator for the velocityindicator for the velocity
The LThe LEDEDlights up when lights up when the output voltage exceeds either the positive orthe output voltage exceeds either the positive or
negative full scale range (peak) of the velocity decoder. If it lights upnegative full scale range (peak) of the velocity decoder. If it lights up
permanently, the next highest range must be selected (refer topermanently, the next highest range must be selected (refer to
sec
sectiotionn 4.24.2.1.1).).
 Analog voltage output for theAnalog voltage output for the signal (BNC jack)signal (BNC jack)
The voltage at this output is The voltage at this output is proportional to the instantaneous vibrationproportional to the instantaneous vibration
velocity of the object to velocity of the object to be measured. The voltage is positive if the be measured. The voltage is positive if the objectobject
is moving towards the scanning head.is moving towards the scanning head.

  
socket for the displacement decoder (BNC jack)socket for the displacement decoder (BNC jack)
This socket allows synchronized resetting of the optional displacementThis socket allows synchronized resetting of the optional displacement
decoder. This input is only active if a displacement decoder is installed.decoder. This input is only active if a displacement decoder is installed.
 Analog voltage output for theAnalog voltage output for the signal (BNC jack)signal (BNC jack)
The voltage at this output is The voltage at this output is proportional to the instantaneousproportional to the instantaneous
displacement of the object to be measured. The output is only active if adisplacement of the object to be measured. The output is only active if a
displacement decoder is installed.displacement decoder is installed.

  
key for key for the displacement decoderthe displacement decoder
Using this key the optional displacement decoder can be reset manually.Using this key the optional displacement decoder can be reset manually.
   keykey
The controller processor can be reset using this key.The controller processor can be reset using this key.

  
LL
EDED

The LThe L
EDED
lights up if the lights up if the controller is being operated remotely via one of controller is being operated remotely via one of thethe
interfaces. Manual operation with the interfaces. Manual operation with the keyskeys
↑↑
,,
↓↓
,,
++
,,
−−
on the front panel ison the front panel is
also possible, however, manual settings are not transferred to thealso possible, however, manual settings are not transferred to the
software.software.

 LL
EDED

This LThis L
EDED
lights up when the statuslights up when the status OCALOCAL OCKOCK UT has been activatedUT has been activated
via the software. The keysvia the software. The keys
↑↑
,,
↓↓
,,
++
,,
−−
on the front panel are thenon the front panel are then
deactivated and the controller is operated exclusively via the deactivated and the controller is operated exclusively via the softwasoftware.re.

Polytec PSV 300 Specifications

General

Brand	Polytec
Model	PSV 300
Category	Measuring Instruments
Language	English