The back panel of the controller is shown inThe back panel of the controller is shown infifigugurere 3.3.22..
combinationcombination
Socket for standard power cord with built-in fuses and Socket for standard power cord with built-in fuses and mains voltagemains voltage
selectorselector
connector (Sub-D jack)connector (Sub-D jack)
Jack for the interferometer cable to the Jack for the interferometer cable to the junction boxjunction box
interface (9-pin Sub-D jack)interface (9-pin Sub-D jack)
Jack for the RS-232 cable to the workstation to control the PSV with theJack for the RS-232 cable to the workstation to control the PSV with the
softwaresoftware
interfaceinterface
output (BNC jack)output (BNC jack)
The DC voltage at this output is proportional to the The DC voltage at this output is proportional to the logarithm of the opticallogarithm of the optical
signal level.signal level.
Figure 3.2: Rear view of the controllerFigure 3.2: Rear view of the controller
disconnect from the mainsdisconnect from the mains
checking the fuses!checking the fuses!
check the settings of the voltage selector and the rating of the fusescheck the settings of the voltage selector and the rating of the fuses
connecticonnecting to the mainsng to the mains !!
To control the PSV using the software, in the controller the transfer rate must be set toTo control the PSV using the software, in the controller the transfer rate must be set to
(refer to(refer tosect
sectionion 5.15.12.32.3))!!
This opening mustThis opening must be kept free to ensure sufficient cooling! The distance from thebe kept free to ensure sufficient cooling! The distance from the
wall should bwall should be at least 50mme at least 50mm !!
To Next Page
Loading...
