The front panel of the The front panel of the workstatworkstation for the ion for the PSV models -H, -F and -U is PSV models -H, -F and -U is shownshown
ininfi
figugurere 3.3.88. The lockable front flap is shown as transparent.. The lockable front flap is shown as transparent.
andand
LL
EDED
The green LThe green L
EDED
(POWER) lights up when the workstation is switched on(POWER) lights up when the workstation is switched on
using the mains switch on the back ausing the mains switch on the back and when the black key on nd when the black key on the front isthe front is
pressed. The red Lpressed. The red L
EDED
being lit indicates the activity of the hard disk drivebeing lit indicates the activity of the hard disk drive
(HDD) in the workstation.(HDD) in the workstation.
keykey
Using this key the control processor of the workstation can be reset andUsing this key the control processor of the workstation can be reset and
the workstation can be restarted. The setting of the workstation isthe workstation can be restarted. The setting of the workstation is
subsequently the same as it was straight after switching on. You cansubsequently the same as it was straight after switching on. You can
press this key through the opening using a thin object.press this key through the opening using a thin object.
This opening mustThis opening must
be kept free to ensure sufficient cooling! The distance from thebe kept free to ensure sufficient cooling! The distance from the
wall shouwall should be at least 50mmld be at least 50mm !!
Figure 3.8: Front view of the workstationFigure 3.8: Front view of the workstation
This opening mustThis opening must
be kept free to ensure sufficient cooling!be kept free to ensure sufficient cooling!
To Next Page
Loading...
