The back panel of the workstation for the PSV models -F and -U is shown inThe back panel of the workstation for the PSV models -F and -U is shown in
fig
figureure 3.13.100. The order of the . The order of the boards can be different from the picture.boards can be different from the picture.
Mains socket with a mains switch and mains voltage selector. Instead ofMains socket with a mains switch and mains voltage selector. Instead of
using the voltage selector, the mains voltage input can also be designedusing the voltage selector, the mains voltage input can also be designed
as a wide range input (refer toas a wide range input (refer tosec
sectiotionn 3.13.1). The mains switch disconnects). The mains switch disconnects
the workstation from the mains (position O) and is used to turn it off inthe workstation from the mains (position O) and is used to turn it off in
case of danger.case of danger.
connector (6-pin circular jack)connector (6-pin circular jack)
connector (6-pin circular jack)connector (6-pin circular jack)
connectorconnector
Jack of the Ethernet network boardJack of the Ethernet network board
port (Universal Serial Bus)port (Universal Serial Bus)
AlternativAlternative jack e jack for peripheral devices like for peripheral devices like mouse, keyboard, etc.mouse, keyboard, etc.
Serial interfaceSerial interface (9-pin Sub-D connector)(9-pin Sub-D connector)
Jack for the RS-232 cable to the junction box to control the video cameraJack for the RS-232 cable to the junction box to control the video camera
Figure 3.10: Rear view of the workstation for the PSV models -F and -UFigure 3.10: Rear view of the workstation for the PSV models -F and -U
If applicable,If applicable,
check the setting of the mains voltage selectorcheck the setting of the mains voltage selector
connecting theconnecting the
workstaworkstation to the mainstion to the mains !!
To Next Page
Loading...
