9.9. Fix thFix the pan-te pan-tilt stailt stage on the coge on the connecnnector box ustor box using the 3 Aling the 3 Allen sclen screwsrews
M8x16 and the washers.M8x16 and the washers.
10.10. Then mount the scanning head with itThen mount the scanning head with its mounting plate on the pan-tils mounting plate on the pan-tiltt
stage using the 2 Allen screws Mstage using the 2 Allen screws M66 xx 16 and the washers as shown in16 and the washers as shown in
fig
figureure 3.13.144..
111.1. Keep the assembly instKeep the assembly instructions for the tripod and pan-tructions for the tripod and pan-tilt stage in a safeilt stage in a safe
place.place.
For cabling the pan-tilt stage, refer toFor cabling the pan-tilt stage, refer tosec
sectiotionn 3.43.4.2.2..
Make sure that the pan-tilt stage is correctly aligned to the connector box! The FRONTMake sure that the pan-tilt stage is correctly aligned to the connector box! The FRONT
labeled sides have to be mounted in the same direction.labeled sides have to be mounted in the same direction.
Make sure that the FRONT labeled sides of the components are mounted in the direction ofMake sure that the FRONT labeled sides of the components are mounted in the direction of
the front panel of the scanning head!the front panel of the scanning head!
Figure 3.14: Mounting the scanning head on the pan-tilt stageFigure 3.14: Mounting the scanning head on the pan-tilt stage
To Next Page
Loading...
