WATERGARDENING TO THE MAXPONDMAX.COM
SKIMMER & WATER
FEATURE PUMPS
IMPORTANT NOTES
• It is important that this procedure is carried out
regularly as the cooling path inside the motor can
become clogged. If the impeller assembly becomes
worn or damaged it should be replaced (available from
your dealer). Failure to do so may cause serious
damage to pump. Inspect for signs for wear and tear.
The impeller set is a wearable part.
• Once the cleaning and inspection process is
completed, reassemble in the reverses manner.
Reinstall the impeller into the motor body.
To place the Impeller O’ring around the black disc
successfully, firmly hold the disc with one hand, and
using the other hand stretch the O’ring over the disc,
positioning it carefully into the groove. Pay attention
not to allow the O’ring to roll forward, in-between the
black disc and the Pump Motor Body.
With the impeller in the correct position, carefully
place the Impeller Cover Housing on, and then rotate
clockwise back into position.
• Now reattach Front Filter Screen to the pump, by
rotating clockwise.
• Now re-attach the Base Plate into position to lock
the impeller cover from turning.
PMAX US EVOII 1800_2400_3000_3600 Pump Instructions.indd 7 30/9/16 6:27 am
To Next Page
Loading...
