TROUBLESHOOTING
Problem Reason Solution
WATER PUMP
NOT WORKING
No Power
Check that the plug is connected and
power point turned on.
Filter Screen or Sponge is blocked with
sludge.
Clean the Filter Screen or Sponge.
Impeller is blocked with sludge or lime
scale build up.
Clean the Impeller as per the instructions.
Running without sucient water.
Submerse the equipment underwater
then plug in. Refill if necessary.
Blocked Impeller chamber or
ceramic shaft is broken.
Clean the Impeller. Check for wear.
Replace if necessary.
WATER PUMP
IS NOISY
Blockage in pump. Clear the blockage.
Impeller & Shaft worn out. Replace Impeller Assembly.
Impeller broken. Replace Impeller Assembly.
Water level in feature is too low.
Refill feature with water to appropriate
height.
Unit inlet is blocked or the water pump
outlet is blocked.
Clear all blockages.
The height to which you are pumping is too
high for the given model of pump.
Select a bigger model.
PMAX US EVOII 700_900_1200 Pump Instructions.indd 10 30/9/16 6:33 am
To Next Page
Loading...
