HEATING
AND
VENTILATION
1-7
Fig.
1-6
Control
Diaphrams-—Pontiac
FIREBIRD
1. Disconnect battery ground and positive
cables,
and remove battery and tray (Fig. 1-9).
2.
Unclip
heater
hoses
from
fender skirt,
3. Scribe alignment marks and remove hood.
4.
Remove
right front fender and skirt as an
assembly.
5. Disconnect the blower motor wire at the motor
flange.
6. Either remove the motor to
case
mounting
screws
and remove motor or remove the two
screws
and
five
nuts
at
dash
to remove motor and duct as-
sembly. Pry duct gently if the
sealer
acts
as an
adhesive.
7.
Remove
the blower wheel retaining nut to
separate
blower and motor.
To Next Page
Loading...
