ENGINE
COOLING
AND
LUBRICATION
6A-5
Fig.
6A-2
Radiator
Support
and
Baffle
Assembly
-
Tempest
NOTE:
To
save
coolant
remove
radiator
overflow
hose
and
connect
to
drain
cock.
3.
Loosen
hose
clamps and disconnect upper and
lower radiator
hoses
at radiator inlet and outlet
pipes.
4.
On cars equipped with automatic transmissions,
disconnect and plug the transmission cooler lines.
5«
Remove upper fan shield (six cylinder) or upper
shroud
bracket
(V-8).
6.
Remove radiator attaching screws and lift
radi-
ator and shroud out of vehicle.
REPLACE
1.
Replace radiator by reversing the above
procedure.
2„
Torque all mounting screws to
12
lb. ft.
3.
Refill
radiator with enough coolant to ensure
all
weather corrosion protection
(-20°F
protection).
ENGINE
OIL
See
GENERAL
LUBRICATION
SECTION.
OIL
PUMP
See
SECTION
6
(ENGINE
MECHANICAL)
OIL
FILTER
A
full
flow filter is standard on all
engines
and is
mounted on the front side of the accessory drive
housing on six cylinder
engines
and the right
rear
of the engine block on
V-8
engines.
6
CYL AND 8
CYL.-REMOVE
AND
REPLACE
Install
a new oil filter at the first oil change and
then every other oil change thereafter.
To Next Page
Loading...
