Pontiac firebird 1968 - Page 304

ENGINE COOLING AND LUBRICATION
6A-7
REMOVE AND REPLACE (400 RAM-AIR ONLY)
1. Place new filter cartridge in engine compart-
ment near filter location,,
2. Raise vehicle „
3. Disconnect old filter cartridge using filter
wrench J 22775.
Fig. 6A-5 8 Cylinder Oil Filter Location
4. Hand tighten filter until gasket contacts filter
base, then tighten a further 2/3 of a turn using
J 22775 for convenience. Do not over-tighten.
5. Lower vehicle.
6. Remove old cartridge from engine compartment.
DRIVE BELTS FOR PONTIAC, TEMPEST & FIREBIRD ENGINE
AND ACCESSORY DRIVE COMBINATIONS
Belt
Width
Belt Name
Borroughs Gauge
Belt
Width
Belt Name
New
Used
3/8"
15/32"
15/32"
3/8"
15/32"
Water Pump and Generator Belt (All 6 Cyl. and 8 Cyl.). . . .
Power Steering Pump Belt (All 8 Cyl. and 6 Cyl. with A.C.) .
A.C. Compressor Belt (All 6 Cyl. and 8 Cyl.)
120 Lbs.
145 Lbs.
145 Lbs.
60 Lbs.
145 Lbs.
75 Lbs.
105 Lbs.
105 Lbs.
50 Lbs.
105 Lbs.